Tel: +86-579-85110216

E-mail: echo166@lacrystalcastle.com

You are here: Home > Knowledge > Content
Daily maintenance and maintenance of scald equipment
- Mar 19, 2018 -

Daily maintenance and maintenance of scald equipment:

1. Pressure: if the pressure is not enough or too large, adjust the pressure screw (located at the bottom of the aluminum plate), the clockwise direction is to increase the pressure, and the reverse clock is to reduce the pressure.

2. Time: when the hot stamping time arrives and the buzzer does not ring or keep ringing, it is necessary to check whether the contact point of the micro switch in the tail box is moderate. If not, it should be adjusted to the appropriate position.

3. Temperature: preheat for about 15 minutes. When the temperature reaches the set temperature, the heating indicator will be off and the hot stamping can start; If the heating plate is not hot for several minutes, please check the wiring.